Whirlpool Washer F10 Error Code

Model Specific Error Code

WFW3090JW WFW5090JW

Drum Overload Error (Over-temperature)

F10

The ACU has detected a temperature that is too high. This error code is hidden from the consumer. The cycle will continue with reduced or no motor movement. This error code is normally not visible during the Service Test Cycle because it is the result of a motor that has been running for a long time under heavy load.

Whirlpool Washer F10 Error Code Error Code Possible Causes

Check the drum for mechanical friction (move the drum slowly and very briefly)
Check for trapped laundry
Check for noise or friction during drum rotation
Check if the washer was overloaded
Check if the washer ran several consecutive and/or
long cycles
Make sure the ambient temperature of the laundry area is not too high
Make sure that the washer installation is correct, particularly if the washer is built-in
Check motor for a defect
Check the ACU

Model Specific Error Code

All Others

Motor Control Error

F10

The Motor Control Unit (MCU) heat sink thermal protector has tripped.

Whirlpool Washer F10 Error Code Error Code Possible Causes

The unit is located too close to a source of heat. Wire harness connections to the MCU, motor or Central Control Unit (CCU).

Worn or failed drive system components.

MCU fault.

Motor fault.

Want more appliance repair information?

Already A Member?

This information is provided for educational purposes only. Please consult the appropriate Service Mode or Technical Document for your model. Always take proper safety precautions when installing or repairing any major appliance.