Electrolux Oven SPr Error Code

Spark Detected Error

SPr

This device detects voltage from spark ignitor harness. If voltage is detected at the AC detect board this will signal to the oven control that the spark module is trying to light a burner. The oven control will only look for the signal from the AC detect board when self- clean cycle is started or running. Detection of the signal will cause clean to be can- celled and “SPR” (which means spark detected) will appear in the display. The cooktop should not be used during a self- clean cycle. On some models, turning on any cooktop surface burner will cause the clean cycle to cancel. If the clean cycle is canceled, the oven control display will show “SPr” for 5 seconds. The oven door will remain locked until the oven has cooled down below cleaning temperature. If the oven is below cleaning temperature, the user can start another clean cycle immediately. If the oven is in cleaning temperature range, another self-clean cycle can be set once the door unlocks (up to 4 hours).

Electrolux Oven SPr Error Code Error Code Possible Causes

Burner turned on during self clean.
AC detect board is defective.
The EOC is defective.
Wiring issue

Want more appliance repair information?

Already A Member?

This information is provided for educational purposes only. Please consult the appropriate Service Mode or Technical Document for your model. Always take proper safety precautions when installing or repairing any major appliance.