Water Leak Error
Water Leak Fill Error. If there is a leak during the water leak detection of the cycle when programmed on, an error will display after the door is opened at the end of cycle for 1 minute. It will clear after 1 minute or when a keypad is pressed. If the water level has increased more than an acceptable amount during a water leak drain check, the control will save a water leak drain error status and will continue the machine cycle. Immediately upon detecting the error the rightmost decimal point will be lit. This lit decimal point can be cleared by pressing the START keypad 3 times in a period of 5 seconds or by cycling the power to the machine. There may be a water valve stuck open due to debris or a failed water valve.
Alliance Washer Er LF Error Code Error Code Possible Causes
- The water valve is defective.
- Restricted drain hose.
- The drain pump is defective.
- The pressure sensor hose or hose is defective.
- The control board is defective.
- Wire harness or connection issue
Want more appliance repair information?
Sign Up Today!Already A Member?
Log In To ViewThis information is provided for educational purposes only. Please consult the appropriate Service Mode or Technical Document for your model. Always take proper safety precautions when installing or repairing any major appliance.