Alliance Washer E Ld Error Code

Water Leak Error

E Ld

Water Leak Drain Error. The control detected that the water level dropped more than the acceptable level. Check the hose connections at the pump for leaks. Check for leaks from the outer tub, and tub seal. If there is a leak during the water leak detection of the cycle when programmed on, an error will display after the door is opened at the end of cycle for 1 minute. It will clear after 1 minute or until a key is pressed. If the water level has dropped more than an acceptable amount during a water leak drain check, the control will save a water leak drain error status and will continue the machine cycle. Immediately upon detecting the error the rightmost decimal point will be lit. This lit decimal point can be cleared by pressing the START keypad 3 times in a period of 5 seconds or by cycling the power to the machine. The cause of this error may be the drain hose leaking or a stuck gravity drain valve on gravity drain machines.

Alliance Washer E Ld Error Code Error Code Possible Causes

The unit is leaking.
Drain hose leaking or siphoning.
The pressure sensor or hose is plugged or defective.
The control board is defective.
Wire harness or connection issue

Want more appliance repair information?

Already A Member?

This information is provided for educational purposes only. Please consult the appropriate Service Mode or Technical Document for your model. Always take proper safety precautions when installing or repairing any major appliance.