Whirlpool Dishwasher Service Bulletins

Under certain circumstances, some customers may experience an inadvertent rack rollout. If the rail system is not level or if the unit is leaning forward, racks can roll out or into the tub without consumer intervention.

In certain circumstances, consumers may experience a Dead or intermient operaon of the UI Console Keypad. Under certain condions, consumers may report the start/cancel buon will operate intermiently or fail to operate.

In certain circumstances, consumers may experience a Dead or intermient operaon of the UI Console Keypad. Under certain condions, consumers may report the start/cancel buon will operate intermiently or fail to operate.

It is possible that consumers may experience slow or no drain, a noisy pump, or a dishwasher that does not complete a cycle. Customers may also see a F9E1 error code (for display models), Blinking Clean Light (for non display models) and/or that the pump does not fully drain out the water. There are multiple potential causes and corrections.

It is possible that consumers may experience slow or no drain, a noisy pump, or a dishwasher that does not complete a cycle. Customers may also see a F9E1 error code (for display models), Blinking Clean Light (for non display models) and/or that the pump does not fully drain out the water. There are multiple potential causes and corrections.

It is possible that some consumers may notice a missing Bent and/or Straight Access panel (see below).

Always inspect the TCO when replacing the ACU. If the thermal fuse is bypassed or disabled, it cannot cut power to the control board if an overheating event occurs. This can result in the control board igniting or emitting smoke, sparks, flames or fumes.

Under-Counter Dishwashers Door Not Sealing Properly/Leak Potential

Consumer may report a new dishwasher is not cleaning, or fills/drains with no spray arm action. In some units this could be caused by wash motor stalling.

Consumer may report a new dishwasher is not cleaning, or fills/drains with no spray arm action. In some units this could be caused by wash motor stalling.