GE Washer Service Bulletins

Profile top load washers in the models listed above may appear to start a cycle when the start button is pressed, by locking the lid, but other loads (water valves, drain pump, drive motor) will not operate. The user interface buttons will respond normally, by producing a tone when pressed, but the washer may not start a cycle.

New combo washer/dryer

Top Load Washer LE Main Board Personality ID Programming

Change Mode Shifter from G004 to G005

The UltraFresh Vent LED may remain on when the LED is expected to turn off. 1. When the power button is used to turn on the washing machine. 2. When the UltraFresh Vent cycle is selected and then attempt to cancel the cycle by turning the knob. 3. Starting an UltraFresh Vent cycle, but the cycle does not start.

When leaving the dispenser drawer open to dry in-between cycles, the drawer is recommended to be opened greater than 1” to ensure the bulk dispenser is fully disengaged from the bulk dispense port. If the drawer if left open less than a 1”, detergent may leak onto the tub gasket, as shown below, or from the bottom of the door.

Change the Askoll drain pump

Mode Shifter Circuit Testing Techniques

Change the Askoll drain pump

Dispenser drawer won’t seat or falls out