GE Dishwasher Service Bulletins

Door Lowers Too Quickly. The door may not stay in a mid-position when partially opened, or it may fall to a fully open position without being pushed down.

Traditionally dishwashers would vent out the upper-left side of the outer panel, through a vent assembly in the inner door using a fan, through the fill funnel, and through the beach gasket located at the bottom of the inner door. Ventless dishwashers do not offer a door vent dry system and only vent through the fill funnel and beach gasket. These dishwashers dry by heating the dishes and racks. Much of this moisture will evaporate or condense on the walls and inner door, and then will run down into the sump. It is normal for some moisture to remain on the door and walls of the inner tub, and this is normal. Educating the consumer will provide the best dry performance for these dishwashers.

Lower Spray Arm Heat Shield Removed

Water or moisture may be seen on the top of the dishwasher door or underneath countertops.

Dishwasher may have had poor dry performance prior to a dead display and SmartHQ Service connection error. Disconnecting dry heat connector from main control board (see mini manual for connector number) causes display to become responsive.

Dishwasher may seem to have a dead display and a gap can be seen on overlay

Water or moisture may be seen on the top of the dishwasher door or underneath countertops.

Poor Drying

Clean Indicator LED Will Not Illuminate

Dishwasher Not Starting and/or Finishing a Cycle